Unless otherwise specified, all of the commands should be run in the terminal or over SSH. This tutorial assumes you already have a device setup with either direct terminal access or SSH access. I was previously running Pi-hole on a Raspberry Pi Zero and with 700k domains blocked it would often take 5-10 minutes to unblock a domain. That being said, some low-end devices can get slow if you add a lot of blocklists. I’ll be running Pi-hole on a Raspberry Pi 4 with Raspberry Pi OS (formerly Raspbian), but it also works well on other models and most other devices running Linux or that have Docker available.
It’s okay if you don’t have an IPv6 enabled network (or don’t want to set it up), these instructions will also work great for a plain IPv4 setup – just skip the IPv6 steps! Same goes for Docker, I’ve included instructions for setting it up with or without.
0 kommentar(er)
